![kodak esp office 2150 installation software kodak esp office 2150 installation software](https://www.freeprinterdriverdownload.org/wp-content/uploads/2016/07/kodak-esp-5200-step3.png)
The package-managed sane library on my system gives the requested 64K size. For some reason, this returns 32K packets, even when you request 64K packets. The issue with 32K vs 64K packets was only in the version of the scanimage program that got compiled with the kodakaio project. I think it may have been adding a byte to all but the last read before. The key change that made it start working on my end was adding one byte to the request size sent to sanei_usb_read_bulk, but only on the last read. Is it possible I missed a step trying to tie the AIO library into the original sane install? Yet /usr/local/bin/scanimage works perfectly. Scanimage (sane-backends) 1.0.22 backend version 1.0.22 Sane_kodakaio_get_devices: found scanner libusb:002:006 Sane_kodakaio_get_devices: found 1 scanner(s) Mc_discover_capabilities: added adf to listĮnd of mc_discover_capabilities, status:Success Mc_set_model: model is 'KODAK ESP Office 2150 Series' If I run /usr/bin/scanimage (linked to the original SANE), I get this as debug output: Setting debug level of kodakaio to 128.Īttach_one_config: len = 17, line = snmp-timeout 1500Īttach_one_config: SNMP timeout set to 1500Īttach_one_config: len = 22, line = scan-data-timeout 7000Īttach_one_config: Scan data timeout set to 7000Īttach_one_config: len = 20, line = request-timeout 5000Īttach_one_config: Request timeout set to 5000Īttach: devname = libusb:002:006, type = 1įound valid Kodak Aio scanner: 0x40a/0x4059 (vendorID/productID)
![kodak esp office 2150 installation software kodak esp office 2150 installation software](https://sm.pcmag.com/pcmag_in/photo/k/kodak-esp-/kodak-esp-6150-controls_6zwx.jpg)
To get the kodak machine to show up in the scanner list for Simple Scan, I did this:ġ) Soft link from all of the /usr/local/lib/sane/kodak files to /usr/lib64Ģ) Edit /etc/sane.d/dll.conf and add a line for kodakaio after kodakĪt this point I see it in Simple Scan, but when I scan I get an I/O error. My Simple Scan seems to be linked to the original SANE installation under /usr/lib64. I can use the scanimage program installed under /usr/local/bin to successfully test the scanner.